Just a little message to say thanks, I have had 1000 people view this little blog of mine. I know a lot of y’all are gluttons for punishment and keep coming back and I appreciate it.  Btw here is a quick pic of getting the horizontal bar mounted 🙂 it’s currently holding half the pack. […]

So I have been semi busy both in real life and on the bike… First we will talk about real life, I am fortunate enough to life really close to Royal Purple raceway and was able to go see John Metrics and the Lone Star EV Drag car (LoneStar EV), Wow what a sight seeing […]

So I know im late and there are a few good reason’s for that. I wont get into my personal life but I was released from my Job 2 Thursday’s ago and have been dealing with dealing with the transition from employed to unemployed, as well as spending a lot of time to finding a […]

Well no real fabrication this week, but a lot of time at the computer and the printer, Designing parts and then printing. This weekend was more designated to the rear tail and the power charger’s and charge points. Yes I said points as I will have 2 on board! I decided that I didn’t want […]

Well my Custom sprocket has arrived from Sprocket Specialist’s and all i can say is wowwww this thing is huge!!!! I didn’t realize how big it was going to be, CAD model’s just don’t do it sometimes! So after i got it and was gwacking at it for a while, I realized I had better […]

Well this will be a unusual post as there is not really a keep theme to it… Its a few updates all rolled into one 🙂 First of I was wondering why i had no more gas in my tank then i found out why… Someone… (My wonderful girlfriend wearing my blue boilersuit) had cut […]

Well tonight was a good night, well for the most part… Started with remounting the motor and attempting to get the plate as flush. Realized that shaft was about an inch short, well then I realized that the top forward and bottom rear bolt were actually castle nut bolts and therefore adjustable 🙂 so with […]

Well i went with the data sheet and it bit me in the butt again… datasheet for the me1117 stated that i needed 3/8 bolts… no mine is different and used m8x1.25… so i get to return all my new shiny hardware, and replace them with shiny M8’s if i can find them…

Well i started working on the fab plate this weekend, ended up getting 3 version’s out of the piece of aluminum I have. Version 1: Started working on it, and  realized i have the first set of holes, about 2 inches too low, so i flipped it over, and started on Version 2… Version 2: […]

Well they are here 🙂 sitting pretty in my garage now 🙂 Also ordered a new 16ton crimp tool so that i can crimp my 70mm (2AWG wire) as well as 25ft of Blue, Red, And Black wire. The blue will be used for the interconnects for all the sub pack’s and then the red […]